I love the new supports but sometimes I have files that I print flat on the plate that just need a few extra supports. The auto and manual supports lift my model up and now I've got a ton of supports. It would be great to be able add supports without the model being lifted up.
The minimal model lift height is set at 4, there's probably a reason for it but supporting my own models I've usually got the models only lifted 1 or 2mm above the plate to shave off a few minutes of build time. Any chance of being able to lower the height below 4?
Support Question
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Support Question
You can set it to 0 now.
We will add lower height in future updates, however from tons of testing 4mm is the optimal raise height for most prints. So that the auto supports can work well.
We will add lower height in future updates, however from tons of testing 4mm is the optimal raise height for most prints. So that the auto supports can work well.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Support Question
nice, i figured there was something I was missing and a reason for 4. thank you
Who is online
Users browsing this forum: No registered users and 6 guests