Support Question

[Kevin]

I love the new supports but sometimes I have files that I print flat on the plate that just need a few extra supports. The auto and manual supports lift my model up and now I've got a ton of supports. It would be great to be able add supports without the model being lifted up.

The minimal model lift height is set at 4, there's probably a reason for it but supporting my own models I've usually got the models only lifted 1 or 2mm above the plate to shave off a few minutes of build time. Any chance of being able to lower the height below 4?

[mongerdesigns]

You can set it to 0 now.

We will add lower height in future updates, however from tons of testing 4mm is the optimal raise height for most prints. So that the auto supports can work well.

[Kevin]

nice, i figured there was something I was missing and a reason for 4. thank you