Parameter incorrect

[printcast]

I'm trying to print a cuff but am getting a print fail parameter incorrect. I tried to slice preview but get the parameter incorrect error there as well. Not sure what the parameter is, but obviously it's incorrect. Anybody know what can be done?

It's a large stl but I did run it through netfab and it's clean.

thx

[Jewelermdt]

Does the cuff fit TOTAL inside the gird pattern. Not sure how you check height limit. Not sure with Contour, but with CW it would show red if it was outside the print area.

[reify]

Hi,

Can you post a pic of the error message? Can you please email the stl to reify3d@gmail.com?

[printcast]

Yes, it does fit in the Contour print area. I'll take a screen shot and paste later today and also try to send the stl as well.

Thank you
Jim

[printcast]

So here's the funny thing. I tried slice preview before using the manual supports in Contour (automatic locked up my low power laptop) and it sliced perfectly. Then put in some manual supports and that's when the parameter error pops up. So, it has to be the supports in Contour.

[exedebee]

So here's the funny thing. I tried slice preview before using the manual supports in Contour (automatic locked up my low power laptop) and it sliced perfectly. Then put in some manual supports and that's when the parameter error pops up. So, it has to be the supports in Contour.

I think this bugs in beta version, you can save scene and load file again.

[reify]

HI,

Can you email the stl to reify3d@gmail.com so I can try to replicate the bug?

[printcast]

Hey Reify,

Sorry for the delayed response. Christmas time is insane. I've been busy finishing the last of my orders that needed to be ship.When I get back in my shop later today that file will be sent.

Jim

[printcast]

Sent.

Please let me know what you find.

Thank you
Jim