I have Z height at 10 try to change it to origional 5 and 5.2 actual it accept the change then reverts back to 10.
This is in both 1.3.3 and 1.3.14 this is both connected to controller and not
Is there a work around
John
Scale Adjustment
Re: Scale Adjustment
Hi John
Not sure what you are trying to do with this. If you are trying to get your machine into calibration by using the scale adjustment tool the best way is to make and print a 10X10X10 cube making sure to identify the X, Y and Z positions. After you print it measure it and put the measurements into the actual scale boxes. This will compensate for the discrepancies in your pieces. Don't forget to click apply then print and measure again to see if it works.
Note the figures in this picture are what my machine needed not what you need to input.
Not sure what you are trying to do with this. If you are trying to get your machine into calibration by using the scale adjustment tool the best way is to make and print a 10X10X10 cube making sure to identify the X, Y and Z positions. After you print it measure it and put the measurements into the actual scale boxes. This will compensate for the discrepancies in your pieces. Don't forget to click apply then print and measure again to see if it works.
Note the figures in this picture are what my machine needed not what you need to input.
- Attachments
-
- scale tool.JPG (19.17KiB)Viewed 10300 times
Re: Scale Adjustment
Thats fine but the Z height is 5mm not 10 and that cannot be changed .
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Scale Adjustment
Your saying it the box that has the Original 10x10x10 yours say's 10x10x5???
If so, I would re install Contour. It should not be that way.
If so, I would re install Contour. It should not be that way.
Re: Scale Adjustment
Results after re install 1.3.14 SC
Print 1: 10x10x5mm X 11.35 Y 8.63 Z 5.1 Now with an angle y- to Y + not parallel to Table
Made adjustments in Scale
Print 2 10x10x5mm X 11.45 Y 9.18 Z 5.2 Still with angled model
Print 3 10x10x5mm X 11.45 Y 10.26 Z 5.2 Still with angled model
Scale made some diff in Y not correct but X does not budge
Print 1: 10x10x5mm X 11.35 Y 8.63 Z 5.1 Now with an angle y- to Y + not parallel to Table
Made adjustments in Scale
Print 2 10x10x5mm X 11.45 Y 9.18 Z 5.2 Still with angled model
Print 3 10x10x5mm X 11.45 Y 10.26 Z 5.2 Still with angled model
Scale made some diff in Y not correct but X does not budge
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Scale Adjustment
If your top row in the Scale window show 10 10 5, then something is way wrong. Contact Emil
Who is online
Users browsing this forum: No registered users and 6 guests