hi friends!
I need some advice because i'm getting bad results with my rings.My rings are heavy so i switch to the taller build plate in 42xy and 25. As seen on the pictures i try to print, i make the supports in manual...But nothing come in print just the first layers on the build plate.......strange...does make a new support?Thanks for your suggestion..
ironfonzy
Heavy ring in 42XY
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Heavy ring in 42XY
Try tilting up a little more. Did you run ring through NetFab or other STL checker? Move the slider up slowly and look to see if there are any islands that you missed supporting.
Re: Heavy ring in 42XY
Hello
Yes i 've checked it by netfab...i will try with more tilt so
Yes i 've checked it by netfab...i will try with more tilt so
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: Heavy ring in 42XY
I would angle it upward more.
Who is online
Users browsing this forum: No registered users and 5 guests