***Totally Stoked!!***

[Archerm]

Your welcome!! I like it because it supports the whole side and it is very easy to clean up as the thickness is minimal.

[Archerm]

[rkundla]

Nice!

Did you have to touch up the engraving any on that ring on the left?

Also, with your horizontal channel ring support, I assume you cut off the support before casting or afterwards?

[Archerm]

Zero touch up on the engraving. The engraving is .50 mm deep a very light sanding and polish. Yes I did cut the the support off the band and just lightly sanded the ring print down on a flat surface after curing.

I did use the new UV lights I revived to cure the prints. They worked very well. I bought two of the Quans 30w lights to cure the parts with. I left the prints in for one hour rotating them every 15 minute. Then microwaved then in distilled 3 times like I normally do. I really like the new UV lights.

Nice!

Did you have to touch up the engraving any on that ring on the left?

Also, with your horizontal channel ring support, I assume you cut off the support before casting or afterwards?

[rsaldivar]

I really like the new UV lights.

which one are you referring to please ??

[Archerm]

Quans 30w or 59w on Amazon.com

[Archerm]

Temporary curing station till I can find a small cabinet to mount the lights in.

[Philip01]

Hello
so nice of you to share all this information,
I am a new to all this, a learning curve for me,
thanks

[M-Williams]

How do you like the LED's so far.

[rsaldivar]

do you have a link , only see 50w for 99.00 ea.