***Totally Stoked!!***

[Dstonic]

Hey there Mike, good to hear from you . Thanks, I didn't know he had two....pretty cool. I posted on here earlier viewtopic.php?f=2&t=963 have problems growing a wide band and was wondering if I should have changed resolution.

[Archerm]

A few prints from last week!! Wanted to post some with the contour supports so Emil can see I do use them!! Haaa Enjoy.

[mongerdesigns]

Ha. Appreciate it Mark. Excellent prints as always.

[Archerm]

Thanks Emil!! From today 42xy. I like to experiment with the supports. They have to look good!! Haaaa

[Archerm]

A few 25xy prints from yesterday.

[Archerm]

Today's prints!!






Tumbled Castings from the above prints.

[Archerm]

A little Celtic weave!!

[Archerm]

We have been doing lots of multi stone bands lately.

[eangor]

Very nice prints. Could you share how you replace your film please? Also, how much do you tighten the thumbscrews? I always have a hard time figuring this out. Thank you.

[Archerm]

I use the Optional Film Install Adaptor. You can Find it here.
http://www.junction3d.com/buy/optional- ... ll-adapter

Then This is how I install the film.
https://www.youtube.com/watch?v=ooT3KamfdrI

After the film is installed I tighten the vat all the way down. Then loosen the thumb screws till the vat starts to be loose. Then tighten the thumbscrews 1/4 to 1/2 turn. Then print.
I paint the slots in the thumb screws white so I can keep track of the turns easier. I also mark the vat so it is always installed the same direction.

Very nice prints. Could you share how you replace your film please? Also, how much do you tighten the thumbscrews? I always have a hard time figuring this out. Thank you.