***Totally Stoked!!***

[Archerm]

I will take a pic for you.

Hope you can post pics of the finished pendant

[reify]

Thank you.

[Archerm]

A customer of mine lost her ring set so it was time to duplicate the set from a photo. Just pulled it off the printer.
render.

[Archerm]

Still stoked guys!! Made the switch to the Emerald and haven't looked back. been printing pretty steady. Lots of parts and pieces as well. Just a few from today. These were printed at .020 z. All you have to do is change the layer thickness in the emerald 30z profile everything else stays the same.

[mongerdesigns]

Mark, those are great! Keep up the great work

[Archerm]

Thanks Emil its been very busy. At the moment I am stripping down the new laptop then going to setup it up for the 42xy Printer.

[Archerm]

Got the go ahead on this piece and printed it this morning. As you can tell I am not support shy !! Its all about the supports. Mark

[mongerdesigns]

That looks smooth! I love the Solus in the background

[Archerm]

Hey everyone. I know we all like to do the big high dollar jobs but there are a bunch of other uses for your printer. In my case I do insurance replacements, lots of rebuilds, and duplicating of lost or damaged pieces. The printer plays a big part for me. A few pieces out of the printer this morning. Mark

[Archerm]

Had a chance to finish these two Tanzanite and Diamond pieces yesterday.