Thanks for sharing Mark, very interesting!
Cheers
Gary
***Totally Stoked!!***
Re: ***Totally Stoked!!***
Thank you for sharing your knowledge and pictures. It is greatly appreciated.
Re: ***Totally Stoked!!***
Super smooth
Re: ***Totally Stoked!!***
Yes they are. I like the tilt on the heavier rings. They print better.
reify wrote:Super smooth
Re: ***Totally Stoked!!***
Nice work, i am building my own supports now and im getting no fails
Thanks
Thanks
Re: ***Totally Stoked!!***
Very good news!! It makes you think a little more about building the model. I don't think it takes much longer to do. Many of the bridges and small supports I build right into the model and hide them for the rendering/
Kerstien wrote:Nice work, i am building my own supports now and im getting no fails
Thanks
Re: ***Totally Stoked!!***
Just pulled this one off the printer!! It amazes me every time I pull a print!! I had to move a smaller space heater near the printer to warm my baby and the resin up a little
Something else I have been going is scaling my STLs in CW to 105%. That allows for a little shrinkage during casting. I tried 110% but that was to much.
Something else I have been going is scaling my STLs in CW to 105%. That allows for a little shrinkage during casting. I tried 110% but that was to much.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: ***Totally Stoked!!***
Wow. Mark. Keep posting those awesome prints!
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: ***Totally Stoked!!***
Hope you can post pics of the finished pendant
Who is online
Users browsing this forum: No registered users and 8 guests