Reify3D Forum

Thank you, Mark.

Archerm wrote:Here you go.

samatheang wrote:Very nice and smooth print, Mark. Good job!

If you don't mind, could you share us screenshots of your profile settings for both 25xy and 41xy please? Thank you.

You know interesting that you said that.
I was thinking about printing a egg with a chicken inside!!

mongerdesigns wrote:Where are the egg prints?

It has been a little while since I posted any prints. It has been busy but wanted to take a few minutes to post a few. Bits and pieces along with a few bands.

As always, great prints, and thanks very much for sharing them!

Still around but have been busy!! A few prints for you!! Nothing fancy just paying the bills!!

Beautiful prints. I'm really impressed my the beaded edge bands.

....and the star shaped cutters use for the stones. Noticed that right off looking down the holes. Nice touch there Mark!

Thanks everyone!! Just doing a few easy prints this week. Most are remakes of customers jewelry that is just worn out. Sometimes it is just easier to remake than repair.

Amazing!

The prints looks amazing! I use that support style for printing horizontally too. It works very well. Thank to you, Mark.

Archerm wrote:Thanks everyone!! Just doing a few easy prints this week. Most are remakes of customers jewelry that is just worn out. Sometimes it is just easier to remake than repair.