Re: ***Totally Stoked!!***
Posted: Fri Oct 06, 2017 2:58 pm
Hello Friend
what projector you used?
what projector you used?
Making Ultra High Resolution 3d Printing Affordable
http://www.reify-3d.com/forum/
diamantelor wrote:Hello Friend
what projector you used?
Archerm wrote:I use the Optional Film Install Adaptor. You can Find it here.
Then This is how I install the film.
After the film is installed I tighten the vat all the way down. Then loosen the thumb screws till the vat starts to be loose. Then tighten the thumbscrews 1/4 to 1/2 turn. Then print.
I paint the slots in the thumb screws white so I can keep track of the turns easier. I also mark the vat so it is always installed the same direction.eangor wrote:Very nice prints. Could you share how you replace your film please? Also, how much do you tighten the thumbscrews? I always have a hard time figuring this out. Thank you.