Page 39 of 42

Re: ***Totally Stoked!!***

Posted: Wed Feb 06, 2019 5:23 pm
by mongerdesigns
Excellent work as usual and supports. Just so you know Mark, we're training an AI to replicate your supports work.... jk....or am I? :)

Re: ***Totally Stoked!!***

Posted: Thu Feb 07, 2019 2:38 am
by Archerm
:mrgreen: You know me I am a support minimalist!! :geek:

Re: ***Totally Stoked!!***

Posted: Wed Nov 27, 2019 1:10 am
by Archerm
Been a while since I printed on my 25xy Solus so I fired it up the past few days. Here are a few prints for you to enjoy! :mrgreen: :mrgreen: :mrgreen:

Image

Image

Image

Image

Re: ***Totally Stoked!!***

Posted: Wed Nov 27, 2019 1:24 am
by Archerm
Image

Image

Image

Image

Re: ***Totally Stoked!!***

Posted: Wed Nov 27, 2019 1:28 am
by Archerm
Image

Image

Image

Image

Re: ***Totally Stoked!!***

Posted: Wed Nov 27, 2019 1:32 am
by Archerm
Image

Image

Image

Image

Re: ***Totally Stoked!!***

Posted: Wed Nov 27, 2019 1:46 am
by Archerm
Image

Image

Image

Image

Image

Re: ***Totally Stoked!!***

Posted: Wed Nov 27, 2019 3:53 pm
by Kokos
Thank you for showing the Rhino picture!!! The prints pictures are often showed. But not the "secret sauce" :)

Will this extruding technique also work with rings with prongs on the sides?

Re: ***Totally Stoked!!***

Posted: Thu Nov 28, 2019 1:09 am
by Archerm
Kokos wrote:Thank you for showing the Rhino picture!!! The prints pictures are often showed. But not the "secret sauce" :)

Will this extruding technique also work with rings with prongs on the sides?

Yes it will. It is very easy and fast. You just have to be careful trimming them. I trim them about 1mm then lightly sand them down to about .1 mm. Then after casting sand off the rest.

Re: ***Totally Stoked!!***

Posted: Thu Nov 28, 2019 1:11 pm
by Kokos
When I have I ring with prongs, I will try your method. Now I am always messing about.