Re: ***Totally Stoked!!***
Posted: Fri Jan 29, 2016 4:21 am
I will take a pic for you.
reify wrote:Hope you can post pics of the finished pendant
Reify3D Forum
Making Ultra High Resolution 3d Printing Affordable
http://www.reify-3d.com/forum/
***Totally Stoked!!***
Page 5 of 42
Re: ***Totally Stoked!!***
Posted: Fri Jan 29, 2016 4:50 am
Thank you.
Re: ***Totally Stoked!!***
Posted: Tue Feb 02, 2016 7:53 pm
A customer of mine lost her ring set so it was time to duplicate the set from a photo. Just pulled it off the printer.
render.
render.
Re: ***Totally Stoked!!***
Posted: Mon Feb 22, 2016 10:28 pm
Still stoked guys!! Made the switch to the Emerald and haven't looked back. been printing pretty steady. Lots of parts and pieces as well. Just a few from today. These were printed at .020 z. All you have to do is change the layer thickness in the emerald 30z profile everything else stays the same.
Re: ***Totally Stoked!!***
Posted: Mon Feb 22, 2016 11:46 pm
Mark, those are great! Keep up the great work 
Re: ***Totally Stoked!!***
Posted: Tue Feb 23, 2016 2:14 am
Thanks Emil its been very busy. At the moment I am stripping down the new laptop then going to setup it up for the 42xy Printer. 
Re: ***Totally Stoked!!***
Posted: Tue Mar 01, 2016 4:57 pm
Got the go ahead on this piece and printed it this morning. As you can tell I am not support shy !! Its all about the supports. Mark
Re: ***Totally Stoked!!***
Posted: Tue Mar 01, 2016 6:21 pm
That looks smooth! I love the Solus in the background
Bits and pieces
Posted: Thu Mar 03, 2016 3:19 pm
Hey everyone. I know we all like to do the big high dollar jobs but there are a bunch of other uses for your printer. In my case I do insurance replacements, lots of rebuilds, and duplicating of lost or damaged pieces. The printer plays a big part for me. A few pieces out of the printer this morning. Mark
Re: ***Totally Stoked!!***
Posted: Tue Mar 08, 2016 4:26 pm
Had a chance to finish these two Tanzanite and Diamond pieces yesterday.
