Re: Prints from Spain
Posted: Thu Jun 07, 2018 12:23 am
Very cool! I haven't had a chance to try the new resin yet. It looks good.
Reify3D Forum
Making Ultra High Resolution 3d Printing Affordable
http://www.reify-3d.com/forum/
Prints from Spain
Page 11 of 11
Re: Prints from Spain
Posted: Wed Sep 26, 2018 9:23 am
Hi there, here are some pics of the new grey resin, so easy to print and such an amazing quality
Re: Prints from Spain
Posted: Wed Oct 24, 2018 10:41 pm
Wich resin do you prefer for making molds with liquid silicone?
red, gray or green?
or you can recommend wich silicone can be used to make good molds? silicone or rubber?
red, gray or green?
or you can recommend wich silicone can be used to make good molds? silicone or rubber?
Re: Prints from Spain
Posted: Mon Jan 21, 2019 9:08 am
studiojoia wrote:rkundla wrote:studiojoia wrote:Here's the ring casted in 18K withe gold.
That surface quality is rock star! Any special technique or just standard burnout?
Just standard burnout, I think clean and curing it's way more important than burnout schedule. I clean with methanol first, IPA second clean, water with dish soap third, and finally water to get rid of the soap.
The curing: 3 times 3 minutes in the microwave in demineralized water, letting it cool between each one. Finally I leave it for the whole night under the UV light in water.
With this method castings are always very good regardless of burnout.
What power do you use when microwave?
Re: Prints from Spain
Posted: Mon Jan 21, 2019 10:59 am
studiojoia wrote:Here's the ring casted in 18K withe gold.
what alloy do you use for white gold???
Re: Prints from Spain
Posted: Fri Mar 15, 2019 3:10 pm
Hi guys! I keep printing with the SolusArt Grey and keep being amazed of the quality it delivers.
Here goes a ring by Lhegacy.
Here goes a ring by Lhegacy.