Time to show off some prints :)
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
Just got everything re-calibrated again.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Time to show off some prints :)
Nice prints Sam. So clean!
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Time to show off some prints :)
Sam are you having success with the casting. If you are,would you mind sharing your schedule?
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
Re: Time to show off some prints :)
lklutts wrote:Sam are you having success with the casting. If you are,would you mind sharing your schedule?
It comes out pretty good if you fully cure it. I just follow Eric's schedule here: http://3dcadjewelry.com/forum/showthrea ... ic+casting
-
- Novice
- Posts:96
- Joined:Mon Mar 28, 2016 8:05 am
Re: Time to show off some prints :)
Amazing Sam! Your prints are so clean.
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
Re: Time to show off some prints :)
studiojoia wrote:Amazing Sam! Your prints are so clean.
Thanks to you and Emil, Jordi. I am still playing with the projector's color temperature and other settings. The Vivitek 1188 is kinda hard since not many people have it, and its setting is different from other projector too.
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Time to show off some prints :)
Glorious!
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: Time to show off some prints :)
Did you cherry. It is way smother and sharper,it also cleans much better than green.
samatheang wrote:studiojoia wrote:Amazing Sam! Your prints are so clean.
Thanks to you and Emil, Jordi. I am still playing with the projector's color temperature and other settings. The Vivitek 1188 is kinda hard since not many people have it, and its setting is different from other projector too.
Who is online
Users browsing this forum: No registered users and 6 guests