Just getting started
Nice to be able to print any model and not have to worry about how to mill.
Re: Just getting started
Thanks Ken
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Just getting started
Those prints look super clean, Joe!
Keep them coming. Great work.
Keep them coming. Great work.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Just getting started
Thanks monger designs.
Re: Just getting started
Being third party, don't always get the right info so reprint this time its going to be casted in two colors not one.
Re: Just getting started
future prints making a note for more supports in thin area. Could not figure out what went wrong until I looked and saw that the area that was hollowed out in the shank is to thin. Live and learn.
Re: Just getting started
Casted and finished piece. Nice machine and set up Mongerdesigns.
Re: Just getting started
Beautiful work Joe. It's always great to see the final product.
Re: Just getting started
Thanks Reify.
I check to see why my print did not print and after checking I forgot to tapper the inside ring that I used to Boolean different with. It came out to .2mm and it was at the start of the failed print. Live and learn.
I check to see why my print did not print and after checking I forgot to tapper the inside ring that I used to Boolean different with. It came out to .2mm and it was at the start of the failed print. Live and learn.
Who is online
Users browsing this forum: No registered users and 118 guests