Just getting started
customer want it in two tone so had to reprint in two pieces. Cast and finished piece.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Just getting started
A-ma-zing!
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Re: Just getting started
Joseph;
Your work and prints are very nice looking, I like the tabbing to help reassemble the prints after casting and cleaning.
The Solus is doing a very nice job for everyone.
Toddmichael
Your work and prints are very nice looking, I like the tabbing to help reassemble the prints after casting and cleaning.
The Solus is doing a very nice job for everyone.
Toddmichael
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
Re: Just getting started
thanks everyone. ToddMichael nothing like having to guess if its lined up again. Tying to learn how to work smarter not harder. LOL
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Just getting started
Fantastic print and casting.
What is your prep please? How do you cure your resin? Burn out temps?
Learning this stuff and appreciate any help.
Mike
What is your prep please? How do you cure your resin? Burn out temps?
Learning this stuff and appreciate any help.
Mike
Re: Just getting started
Hi Mike
I do not do my own casting. For the cure time on the resin I put in a black light box (figure nail box) for about 45 minutes and then in a toaster oven for 90 minutes at 250 degrees. Maybe some of the caster will chime in on how they set up the burn out time.
Thanks
Joseph
I do not do my own casting. For the cure time on the resin I put in a black light box (figure nail box) for about 45 minutes and then in a toaster oven for 90 minutes at 250 degrees. Maybe some of the caster will chime in on how they set up the burn out time.
Thanks
Joseph
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Just getting started
Thanks for the curing info. Tried a couple of ways. Still have a ways to go. Can't do much till I get my printer back up and running.
Re: Just getting started
a few more. Its so nice to be able to make a model and not have to worry about milling it and cutting out for the hollow part of the shank.
Re: Just getting started
sharing. Did not finish the arrow head for it was for someone else. Just had it cast. They finished it. Its an elk tooth.
Who is online
Users browsing this forum: No registered users and 6 guests