Two headed Snake by Nacho Riesco

[mongerdesigns]

Two headed Snake by Nacho Reisco. Printed on the Solus at 25xy30z resolution. 3 hours and 45 minutes total print time.

[CADjewelrySchool]

WOW! Just WOW! Emil. Awesome print.
Is that model printed with the prototype Solus castable resin rather than cherry? It looks a different color.

Would be good to know the vertical (Z height) build speed if that is the prototype new resin.
What is the approx height of the build (with supports)?

[mongerdesigns]

Hi Rik,

Yes, it's the prototype resin. The print including the supports is approx. 44mm tall. Took 3 hours and 45minutes at the 30 micron Z setting. So not bad. Since it's a very low viscosity resin, we can have shorter settle times, which can speed up things a lot.