Page 1 of 18
Prints by Monger
Posted: Thu Nov 12, 2015 12:52 am
by mongerdesigns
I wanted to start this thread, so that I can post prints here instead of keep on making new threads.
Print of a model by Bruno Ribeiro
Posted: Thu Nov 12, 2015 12:52 am
by mongerdesigns
It's a part of bracelet link. I left it in the sun to cure for too long and it curved a little.
Re: Prints by Monger
Posted: Thu Nov 12, 2015 6:46 am
by robin
what if we placed "supports" on the edges to pin it down while it's curing? I don't see any harm and it could prevent it from folding up due to shrinkage on larger sized pieces.
Re: Prints by Monger
Posted: Thu Nov 12, 2015 1:08 pm
by toddmichael
This is the first I am hearing about shrinkage. Is it possible to have shrinkage and how much to anticipate on larger pieces?
I am currently working on 4 pieces that are larger then 50 x 50 and 8 with walls and surfaces .9 to 1.5?
Toddmichael
Re: Prints by Monger
Posted: Sun Jan 17, 2016 1:33 am
by mongerdesigns
Playing with the green resin. Printed this snake ring designed by Nacho Riesco.
https://www.youtube.com/watch?v=zCExeMjH9-U
Re: Prints by Monger
Posted: Thu Jan 21, 2016 10:46 pm
by mongerdesigns
Re: Prints by Monger
Posted: Fri Jan 22, 2016 2:59 am
by Jewelermdt
So is that the Solus Resin?
Looking good.
Re: Prints by Monger
Posted: Mon Feb 01, 2016 7:39 pm
by mongerdesigns
A print I did for a customer, Richard Hall. Great modeling skills. The spoon is 72mm long.
Showing with supports and supports removed.
Re: Prints by Monger
Posted: Tue Feb 02, 2016 12:53 am
by Archerm
Very neat!! Spoon ummm
Re: Prints by Monger
Posted: Tue Feb 02, 2016 5:23 am
by rkundla
Were all the supports for that spoon done with Creation Workshop, or another tool?
Great detail! What are the other dimensions of the spoon?