Hi everybody,
I need some help from this great community.
I started getting cracks in my emerald prints. The interesting moment is that the cracks do not have the “flashy” surface of the emerald when broken, but they are rather rough.
It seems to me that i have prolems with projecting the image of the slices.
I got those few months ago, and since my bulb was due to replace, after the new bulb the problem disappeared for a while.
But it also might be software issue.
Any suggestions appriciated!
Thank you!
Cracks in Emerald prints, need help!
Re: Cracks in Emerald prints, need help!
Since it didn't heal itself during printing, it could be lack of support causing stress on the part during exposure and then peel. That causes those pieces to shift back and forth during the printing process.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Cracks in Emerald prints, need help!
I would make my support post larger and the point size a little larger also. It's surprising how much this affects the print.
Re: Cracks in Emerald prints, need help!
this might not be a print solution , but from the pic , seems to me that you can salvage this with superglue , it will still cast
Who is online
Users browsing this forum: No registered users and 12 guests