ResinWorks EasyCastHD castable resin
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Jesse, have you tried bumping up your exposure a bit?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: ResinWorks EasyCastHD castable resin
I'm getting some problems with this reisins also.
Big pieces uncured reisins in tank.
One good think does not smell this reisins.
Big pieces uncured reisins in tank.
One good think does not smell this reisins.
Re: ResinWorks EasyCastHD castable resin
hasd81 wrote:Good day everyone,
First i would like to say I'm loving this new resin it prints super easily with little to no failures. I am however getting a bit of troubles with the casting of the resin. I use a local casting house and they are vey god but think I'm the first to use this resin. Can any one tell me if they have seen this before? If so what solution did you come up with?
Many thanks
Steve O
The problem with this casting is the preparation of the plaster, it is very watery or very hot when pouring the metal into the tube.
Who is online
Users browsing this forum: No registered users and 124 guests