Page 4 of 8
Re: ResinWorks EasyCastHD castable resin
Posted: Sat Jan 26, 2019 6:31 am
by A.Joa1
Easycast is a good resin. Almost identical to Emerald. Maybe, maybe slightly sharper. Maybe because of the slightly less exposure time which makes it also a bit faster which is a plus.
I would switch just to support the Solus team.
Re: ResinWorks EasyCastHD castable resin
Posted: Sat Jan 26, 2019 6:42 pm
by Kokos
How is the castabilty? The prints look nice and crisp.
Re: ResinWorks EasyCastHD castable resin
Posted: Sun Jan 27, 2019 7:36 am
by A.Joa1
Kokos wrote:How is the castabilty? The prints look nice and crisp.
The same as the Emerald. I will make another thread comparing the 2 when i find time.
Re: ResinWorks EasyCastHD castable resin
Posted: Thu Jan 31, 2019 9:56 pm
by emild
I have a big question:
burnout chedule have a 2C per minunte. All ramp have 2 C per minute for option 2... but if you calculate will not reach the temperatures??
can anyone make clear ?
is 2C per minute for option 1 burnout or for both burnout options?
Thank you
Re: ResinWorks EasyCastHD castable resin
Posted: Thu Feb 21, 2019 1:32 pm
by robin
How sticky is this resin compared to B9's Emerald?
Re: ResinWorks EasyCastHD castable resin
Posted: Thu Feb 21, 2019 5:14 pm
by mongerdesigns
Not sticky at all. It's a really good resin. I suggest printing at 42xy build area with it for best results. Haven't had a single bad print or bad casting. It's miles better than the emerald and easier to post cure. Just cure in water for 30min - 1 hour under UV. Or for better results in glycerin or water/glycerin mix. Turns into hard plastic when completely cured.
Re: ResinWorks EasyCastHD castable resin
Posted: Thu Feb 21, 2019 6:11 pm
by Mikkopee
mongerdesigns wrote:Not sticky at all. It's a really good resin. I suggest printing at 42xy build area with it for best results. Haven't had a single bad print or bad casting. It's miles better than the emerald and easier to post cure. Just cure in water for 30min - 1 hour under UV. Or for better results in glycerin or water/glycerin mix. Turns into hard plastic when completely cured.
With what investment and burncycle?
Re: ResinWorks EasyCastHD castable resin
Posted: Thu Feb 21, 2019 6:23 pm
by mongerdesigns
That info was mentioned in this thread.
Re: ResinWorks EasyCastHD castable resin
Posted: Thu Feb 21, 2019 10:25 pm
by robin
mongerdesigns wrote:Not sticky at all. It's a really good resin. I suggest printing at 42xy build area with it for best results. Haven't had a single bad print or bad casting. It's miles better than the emerald and easier to post cure. Just cure in water for 30min - 1 hour under UV. Or for better results in glycerin or water/glycerin mix. Turns into hard plastic when completely cured.
That's perfect! I'm starting to run low on my Emerald resin so I'll order an Easycast bottle next time. Thanks Emil.
Re: ResinWorks EasyCastHD castable resin
Posted: Mon Feb 25, 2019 4:33 pm
by rsaldivar
does the brow have wax in it ?