SolusArtGrey failure
Posted: Mon Jan 14, 2019 3:31 pm
My first print with SolusArtGrey, fresh FEP, Contour 2.1.17 Beta on default settings:
ImageA
ImageB
The supports are still connected to the build plate, but most of the print remains on the FEP blocking light to prevent further progress. Surprisingly difficult to remove from the FEP using the silicone spatula.
I've been having similar problems with the SolusProto lately, but put it down to being at the end of the bottle. Any suggestions?
ImageA
ImageB
The supports are still connected to the build plate, but most of the print remains on the FEP blocking light to prevent further progress. Surprisingly difficult to remove from the FEP using the silicone spatula.
I've been having similar problems with the SolusProto lately, but put it down to being at the end of the bottle. Any suggestions?