Page 3 of 3

Re: EasyCast HD Print problems

Posted: Fri Jul 26, 2019 3:34 pm
by joeyalbano
Hi guys,

Can anybody tell me why my prints are coming out skewed? for example the coin I made are coming out oval not round, see picture please. If anybody can help, it'll be great. Thanks guys.

Re: EasyCast HD Print problems

Posted: Sat Jul 27, 2019 6:12 pm
by mongerdesigns
Check and make sure your grid had the correct aspect ratio.

Re: EasyCast HD Print problems

Posted: Mon Jul 29, 2019 11:47 am
by joeyalbano
Hi Monger,

I just used the default settings, should I modify it? Attached is the grid that I'm using.

Re: EasyCast HD Print problems

Posted: Tue Jul 30, 2019 11:46 am
by joeyalbano
Hi Guys,

Any suggestions?

Re: EasyCast HD Print problems

Posted: Tue Jul 30, 2019 3:22 pm
by mongerdesigns
You gotta measure it on the glass (projecting it on a paper). Make sure the width and length are correct.

Re: EasyCast HD Print problems

Posted: Wed Aug 14, 2019 3:16 pm
by Jubiler
Hello everyone! What can cause this problem of print.
Some prints coming ok but some they are like cut .
After printing I have in tank some uncured big pieces of resins.

Re: EasyCast HD Print problems

Posted: Sat Nov 23, 2019 10:47 pm
by emild
I have a question and is not the problem with the bulb is new projector..100 hours used. anyone can help?

print with 25nm x 30nm

i spoted the marks on the pictures. looks like mess

how can i have clean prints ?

is maybe contrast and brightness on the nvidia settings ??

Re: EasyCast HD Print problems

Posted: Mon Nov 25, 2019 6:05 pm
by Kokos
Filter the resin before and after use. Also try maybe a slightly lower exposure time for the base layers. They appear to have some bleeding.
Check your model if it is 100% watertight. And look in the slicer if you see weird spots on the places that have the resin dirt.

I just looked again. Maybe it is dirty alcohol or whatever you use to clean the models. Or not cleaning them well enough. Then the dirt can stick to the model and when post-curing it will bake to the model. I have had that on some occasions.

Re: EasyCast HD Print problems

Posted: Tue Nov 26, 2019 8:04 pm
by emild
thanks.