Page 1 of 1

Reins pro

Posted: Wed Dec 11, 2019 5:26 pm
by AV Designs
Hey all which setting do we use for the wax pro resin. I can't seem to get it to go. :roll:

Re: Reins pro

Posted: Wed Dec 11, 2019 8:53 pm
by Jules
are you talking about the Soluswax Pro resin?

Make sure your running version 2.3.4 or newer of solus contour.

It should be listed in the Resin Profile

Re: Reins pro

Posted: Thu Dec 12, 2019 4:43 am
by AV Designs
yes the soluswax pro, but its not listed under that name of pro, I used the settings they had but its not printing. I went back to green and its printing, soo. my other settings work. maybe its a bad batch. this is not what I expected to see even if it is a small sample. I did download the update, so that's not the problem. I'm just frustrated that its always touch and go.

Re: Reins pro

Posted: Thu Dec 12, 2019 8:29 am
by mongerdesigns
If it’s not listed under “SolusWax pro” then you’re not using the correct profile.

Re: Reins pro

Posted: Fri Jan 10, 2020 12:43 am
by AV Designs
question, on some of the new resins where you can adjust the light intensity, the first layer is bright white light, and then after that its the uv blue light. is that normal, and if it is, is there a setting just to make all the layers uv including the first layer.

Re: Reins pro

Posted: Sat Jan 11, 2020 4:18 am
by Jewelermdt
you must not have the latest profiles. It is listed as Solus Wax Pro in the pull down menu. make sure you have Contour set for Beta for it to update.