Page 1 of 1
Help with slicing profile for new Maker Juice resin
Posted: Mon Apr 04, 2016 9:24 pm
by Haresear
Can anyone help with the slicing profile. I created one but the build time is way longer then it should be. This is what they had on their site -
Solus Settings
30μm Layers
Burn in: 15 seconds per layer, 10 layers
All others: 800-1200 ms per layer
honestly I don't know what I'm doing.
Re: Help with slicing profile for new Maker Juice resin
Posted: Mon Apr 04, 2016 11:07 pm
by Haresear
well it prints very nice! I am currently curing it under UV. I must be close to the right slicing profile. I don't know how to insert a pic here so I will put it on 3dcadjewelry
Re: Help with slicing profile for new Maker Juice resin
Posted: Tue Apr 05, 2016 12:09 am
by mongerdesigns
Waiting to get my bottle so I can test it and release a profile. Hopefully by the end of the week. Not sure what kind of shipping they used.
Re: Help with slicing profile for new Maker Juice resin
Posted: Tue Apr 05, 2016 12:10 am
by mongerdesigns
Haresear wrote:well it prints very nice! I am currently curing it under UV. I must be close to the right slicing profile. I don't know how to insert a pic here so I will put it on 3dcadjewelry
To insert a photo, click on Attachements, then upload the file, then click on INLINE, then Submit.
Re: Help with slicing profile for new Maker Juice resin
Posted: Tue Apr 05, 2016 2:16 pm
by sgraber
Haresear wrote:Can anyone help with the slicing profile. I created one but the build time is way longer then it should be. This is what they had on their site -
Solus Settings
30μm Layers
Burn in: 15 seconds per layer, 10 layers
All others: 800-1200 ms per layer
honestly I don't know what I'm doing.
How long did it take to print and what were your settings?
Re: Help with slicing profile for new Maker Juice resin
Posted: Fri Apr 22, 2016 9:27 pm
by Jubiler
Hello! Did you guys find out correct profile for the this reisns?