Not been happy with the prints. Detail not there.
Did a 10mm square for test print. Checked grid cal/fresh juice...
I'm guessing my support is not adequate??? bottom layers separated.
SLIGHT curve at top of cube
Dimensions are off, too. off enough for small milgrain.
Maker Juice
.025
1900
15000
Suggestions?
Just Bob
Test "square"
Re: Test "square"
This is MakerJuice? SF?
You need more supports under the base. You can adjust the XY dimensions with the adjust button found on the Configure Page page in the Build Area box.
You need more supports under the base. You can adjust the XY dimensions with the adjust button found on the Configure Page page in the Build Area box.
Re: Test "square"
reify wrote:This is MakerJuice? SF?
You need more supports under the base. You can adjust the XY dimensions with the adjust button found on the Configure Page page in the Build Area box.
Just MJ
So...what's the concept in adjusting the XY?
Are you talking about in the 3D View screen, then SCALE % and adjust?????
Don't see anything in Configure tab except "MAchine controls" and the XY box unchecked.
CONFUSED
Sorry, this is ALL NEW TO ME!
B
Re: Test "square"
That MJ resin has a lot of shrinkage and you'll need to add a ton of pigment to get it to hold details. The extra pigment will cause other problems though.
The adjust button is on the Configure -> Configure Machine page:
The adjust button is on the Configure -> Configure Machine page:
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Test "square"
Bob,
Project that square onto a piece of paper placed on top of the quartz and measure it. Make sure you're getting a perfect 10x10 square first.
Project that square onto a piece of paper placed on top of the quartz and measure it. Make sure you're getting a perfect 10x10 square first.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Test "square"
Hey Bob try printing the cube standing on one corner with one large support 3mm. Or try printing it flat. Large flat surfaces need to be offset to get a great print. I also think that you will not get the sharp detail with the MJ resin. Just the nature of the beast. The cube below has 8 supports on the bottom. Mark
Who is online
Users browsing this forum: No registered users and 167 guests