Fail ring print with B9 Emerald

[Jewelermdt]

Might need to double check your display settings. the flashing I believe is because something is not set right.

[mongerdesigns]

Yes. Looks like the full rgb issue. Make sure to follow the setup instructions step be step.

[Joetrfj]

I have the same issues with Emerald by itself. Used all suggested settings but 9/10 always had failed prints with massive amounts of flashing, never got to the bottom of why it did it. Mix a little MJ wax cast into the emerald thoroughly, it solved the problem for me.

Joe

[coolmoon]

Hmmm....... What projector are you using and is the uv filter removed?

[kghjewelry]

I'm using the Optoma HD37 1080p 3D DLP Home Theater Projector. Yes I remove the filter. I did print a couple of things but more failures than success.

I rechecked the projector settings and they were not correct. I made the corrections now printing. I'll provide status one cycle is complete.

My print is still failing.

[mongerdesigns]

You had the wrong settings and it failed? Now you have the right settings and it failed again? Maybe you can post a photo? Still getting flashing around the bases?

[kghjewelry]

[kghjewelry]

In tools and tips the following note was posted. I don't see how to check these settings.

For the Optoma HD37, we recommend the following settings.

DISPLAY MODE: Reference
Brightness: 0
Contrast: 15
Sharpness: 15
Gamma: 1.8
Lamp Mode: ECO
High Altitude: On

Note: The Power Mode should remain unchanged on Active, not Eco. This is not the same as the Lamp Mode.

[mongerdesigns]

You use the remote control for the projector to set those settings on the projector menu. Kinda important.

[kghjewelry]

I went back and checked all my setting. Misted one setting in the projector. The print was better but still failed. I added some MJ cast to the emerald green and it worked.