Does anyone use a heat cured silicone to make molds of the SolusProto resin? Is so, which one works for you?
I tried using my Zero-D 4x Zeroshrink rubber but it wouldn't cure around the print.
Thanks.
SolusProto & Heat Cured Silicone Molds
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: SolusProto & Heat Cured Silicone Molds
Mark Miller recommended the Castaldo pink no shrink vulcanizing rubber. Give it a try.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: SolusProto & Heat Cured Silicone Molds
On the B9 resins, I use both castaldo pink can green, but the spray is the trick. Or a dry Teflon spray
https://www.riogrande.com/Product/Casta ... ray/701104
https://www.riogrande.com/Product/Casta ... lbs/701005
https://www.riogrande.com/Product/Casta ... ray/701104
https://www.riogrande.com/Product/Casta ... lbs/701005
Re: SolusProto & Heat Cured Silicone Molds
maveagle wrote:Does anyone use a heat cured silicone to make molds of the SolusProto resin? Is so, which one works for you?
I tried using my Zero-D 4x Zeroshrink rubber but it wouldn't cure around the print.
Thanks.
Another answer that may help:
viewtopic.php?f=5&p=3146#p3146
Who is online
Users browsing this forum: No registered users and 156 guests