Formlabs castable
Posted: Sat Nov 05, 2016 3:45 am
Yay,
I got my Solus 3d printer set up and ready to go, but..... I had not ordered b9 emerald resin.
Excited and ready to start printing I said what the heck, I will put the Formlabs castable and see how it goes.
Used settings for b9 emerald for the ring and it was over exposed, "That only means that the exposure time is much shorter."
Long story short, 2.7 seconds to 1.0 seconds exposure time, that is fast. I think It is till a little over exposed, but we are talking about splitting hairs.
When I get b9 emerald I will compare it.
Pictures I have seen of B9 emerald are great (I cant wait to print with b9 emerald) and faster results from Formlabs castable are also great.
I feel that it comes down to what one wants, cheaper resin or faster higher price resin.
Good choices for everyone!!!
The model is made to set 1mm round diamonds on the side.
I got my Solus 3d printer set up and ready to go, but..... I had not ordered b9 emerald resin.
Excited and ready to start printing I said what the heck, I will put the Formlabs castable and see how it goes.
Used settings for b9 emerald for the ring and it was over exposed, "That only means that the exposure time is much shorter."
Long story short, 2.7 seconds to 1.0 seconds exposure time, that is fast. I think It is till a little over exposed, but we are talking about splitting hairs.
When I get b9 emerald I will compare it.
Pictures I have seen of B9 emerald are great (I cant wait to print with b9 emerald) and faster results from Formlabs castable are also great.
I feel that it comes down to what one wants, cheaper resin or faster higher price resin.
Good choices for everyone!!!
The model is made to set 1mm round diamonds on the side.