Formlabs castable
I am using Optoma.
Re: Formlabs castable
Are you using version 1 or 2 of the form-labs castable resin? There should be a code on the bottle.
Re: Formlabs castable
I still do have some castable 01 but it is no longer being produced so I decided to use
castable 02 because if it worked that was the one that I could re-order.
Will continue testing. So far so good.
Don't know if Emils recommended settings will work. I hope so.
castable 02 because if it worked that was the one that I could re-order.
Will continue testing. So far so good.
Don't know if Emils recommended settings will work. I hope so.
Re: Formlabs castable
eg123 wrote:I still do have some castable 01 but it is no longer being produced so I decided to use
castable 02 because if it worked that was the one that I could re-order.
Will continue testing. So far so good.
Don't know if Emils recommended settings will work. I hope so.
Ok. Thanks. Hope to hear how well it casts. I've heard mixed things.
Anyone else got experience casting the formlabs resin?
Re: Formlabs castable
My castings with Formlabs 02 have been good but I have just recently started doing castings.
My Electromelt is down right now and next week I will be casting.
Sent the casting out for this ring.
Casting is platinum and Not printed with Solus since I had was not set it up at the moment.
My Electromelt is down right now and next week I will be casting.
Sent the casting out for this ring.
Casting is platinum and Not printed with Solus since I had was not set it up at the moment.
Re: Formlabs castable
eg123 wrote:My castings with Formlabs 02 have been good but I have just recently started doing castings.
My Electromelt is down right now and next week I will be casting.
Sent the casting out for this ring.
Casting is platinum and Not printed with Solus since I had was not set it up at the moment.
Have you had to put the UV filter back into the projector, to use this resin?
Re: Formlabs castable
I have done Solus recommendation, no filter.
Re: Formlabs castable
eg123 wrote:I have done Solus recommendation, no filter.
Thanks.
Re: Formlabs castable
Have you got the chance to cast Emerald yet?
Re: Formlabs castable
printcast,
I will be casting Emerald later this week.
As long as the resin is fully cured one should have no problem.
Since I started using the Lizard light to cure the resin, I have had no major issues with my castings.
I will be casting Emerald later this week.
As long as the resin is fully cured one should have no problem.
Since I started using the Lizard light to cure the resin, I have had no major issues with my castings.
Who is online
Users browsing this forum: No registered users and 4 guests