Do you guys do anything to scale the models when growing in Yellow ?
I feel link my models are coming out a little small like .2 or.3mm
Yellow Shinkage
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Yellow Shinkage
The latest version of contour allows you to compensate for the resin shrinkage. It's in File/Setup.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Yellow Shinkage
mongerdesigns wrote:The latest version of contour allows you to compensate for the resin shrinkage. It's in File/Setup.
any ideas on where I should start on the %? its a small amount..
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Yellow Shinkage
For the Scaling module, you enter the measurements that you need to get and what you're actually getting, and the software will compensate.
If you're just going to scale in contour, then it's hard to say for the yellow, but for the emerald, people have seen shrinkage of about 1.5%
If you're just going to scale in contour, then it's hard to say for the yellow, but for the emerald, people have seen shrinkage of about 1.5%
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 14 guests