Page 9 of 10
Re: Introducing the SolusCast resin
Posted: Mon Aug 28, 2017 1:15 am
by wawatobi
When will this resin be available in canada?
Re: Introducing the SolusCast resin
Posted: Mon Aug 28, 2017 4:52 pm
by KBS756
Whats the burnout schedule on this like? does it work well for stone in place type casting? (assuming since its resin it won't melt around stones like wax?
Re: Introducing the SolusCast resin
Posted: Mon Aug 28, 2017 5:24 pm
by mongerdesigns
Recommended Investment: Kerr Satin Cast #20 for Platinum use we recommend Ultra-Vest.
1. Regular Castings Ladies Rings, Pendants, Filigree & Intricate Wax Patterns 40 ml water to 100 g powder
2. Heavy Castings Heavy Ladies Rings, Men’s Rings & School Rings 38 ml water to 100 g powder
3. 8 Hour Cycle (Round Flask: (89 x 100 mm)
4. 2 hours @ 300ºF/149ºC - Initial Wax and Water Elimination
5. 1.5 hours @ 725ºF/382ºC - Trapped Wax Elimination
6. 2.5 hours @ 1415ºF/768ºC - Wax Elimination
7. 1 hour @ 1220ºF/660ºC - Complete Elimination
8. 1 hour to Casting Temp
9. Casting
Re: Introducing the SolusCast resin
Posted: Tue Aug 29, 2017 9:57 pm
by rkundla
What does the cool down from 1415 to 1220 buy you in terms of elimination of the ash from the resin?
This is the first time I've seen a staged drop from peak temperature to casting temperature.
Re: Introducing the SolusCast resin
Posted: Tue Aug 29, 2017 10:12 pm
by mongerdesigns
Wish I could tell you. It's a burnout developed for us by jewelryservices.com
They never miss with their castings. All perfect results, so must be doing something right
Re: Introducing the SolusCast resin
Posted: Sat Sep 02, 2017 7:17 am
by A.Joa1
How much heat (degrees) can SolusCast withstand when put in oven (for annealing) or in the vulcanizer (when making rubber molds) before skin starts to crack?
Re: Introducing the SolusCast resin
Posted: Thu Sep 07, 2017 5:46 pm
by goldfish2
Re: Introducing the SolusCast resin
Posted: Thu Sep 07, 2017 5:56 pm
by mongerdesigns
Great news Bill! Please post some pics if you can. You're using our UV curing unit correct?
Re: Introducing the SolusCast resin
Posted: Fri Sep 08, 2017 1:25 am
by Jewelermdt
I'm having issues getting mine to print. It prints the supports great, but my models don't attache. Iv'e tried three times and get same results with different models. When I opened my bottle there was a lot of gummed up resin at the cap. Even after shacking. Been very busy the last few day and haven't had time to play. And now I may have to get ready for Irma, depending where it goes.
Re: Introducing the SolusCast resin
Posted: Fri Sep 08, 2017 2:39 am
by mongerdesigns
How thin are the support tips? The initial supports that "hold" the model need to have thicker support tips. At least 0.3mm and ball tips.