Page 8 of 12
Re: SolusCast: Cracks in heavy model
Posted: Tue May 08, 2018 8:29 pm
by M-Williams
Here is a new print.
Re: SolusCast: Cracks in heavy model
Posted: Tue May 08, 2018 8:30 pm
by mongerdesigns
Nice print, Mike. Which resin is that?
Re: SolusCast: Cracks in heavy model
Posted: Wed May 09, 2018 11:40 am
by kostyo
epic m.....
Re: SolusCast: Cracks in heavy model
Posted: Wed May 09, 2018 1:06 pm
by M-Williams
Emerald, Epic. 50%
Re: SolusCast: Cracks in heavy model
Posted: Wed May 09, 2018 2:19 pm
by kostyo
@mark why mixing emerald and epic?
now I bought a new bottle and is 100eur cheaper than last year...
Re: SolusCast: Cracks in heavy model
Posted: Wed May 09, 2018 4:09 pm
by M-Williams
kostyo wrote:@mark why mixing emerald and epic?
now I bought a new bottle and is 100eur cheaper than last year...
Simple. the print quality is beyond any expectation . Even though the Epic casts good, but with the Emerald mix, the casting result is superior.
I will post some close-up pics.
Re: SolusCast: Cracks in heavy model
Posted: Wed May 09, 2018 5:20 pm
by kostyo
@mark this print 25mikrons or 42?
I also thought I was trying to mix the emerald with the epic, but I am very happy as the epic cast now when I tuned postcuring.
but I'm curious about your photos
Re: SolusCast: Cracks in heavy model
Posted: Wed May 09, 2018 6:58 pm
by printcast
Where can Epic be purchased?
Mix 50/50 Epic/Emerald. Are you using Emerald settings for printing? I assume the burnout for Emerald will be fine for this 50/50.
Thx
Re: SolusCast: Cracks in heavy model
Posted: Thu May 10, 2018 1:48 am
by M-Williams
kostyo wrote:@mark this print 25mikrons or 42?
I also thought I was trying to mix the emerald with the epic, but I am very happy as the epic cast now when I tuned postcuring.
but I'm curious about your photos
25 microns All the way. The only one setting we use.
Re: SolusCast: Cracks in heavy model
Posted: Thu May 10, 2018 1:20 pm
by printcast
HEY! Looks like we have a new castable resin on the way, SolusWax. The name alone sounds promising to me. Can not wait for a clean easy burnout.