Page 1 of 1
my recent castings
Posted: Mon May 21, 2018 10:54 pm
by rsaldivar
not perfect but good enough for me
Re: my recent castings
Posted: Mon May 21, 2018 10:54 pm
by rsaldivar
more
Re: my recent castings
Posted: Mon May 21, 2018 11:08 pm
by rsaldivar
I would include the STL's , but I don't know how to load it ? sorry
Re: my recent castings
Posted: Mon May 21, 2018 11:09 pm
by mongerdesigns
Those are really good! Lettering is always a challenge. Looks like you got it down.
Re: my recent castings
Posted: Tue May 22, 2018 4:34 pm
by rkundla
Nice clean lettering. Did you apply investment to the lettering first before investing the full flask?
Re: my recent castings
Posted: Fri May 25, 2018 4:50 pm
by rsaldivar
finished
Re: my recent castings
Posted: Fri May 25, 2018 5:05 pm
by mongerdesigns
Did you over-polish the lettering? It's all rounded and less detailed now compared to the rough casting.
Re: my recent castings
Posted: Fri May 25, 2018 6:34 pm
by rsaldivar
yes , a little , I kept until the pits went away
Re: my recent castings
Posted: Sat May 26, 2018 12:58 am
by exedebee
clean casting.
Re: my recent castings
Posted: Sat May 26, 2018 1:00 pm
by M-Williams
rsaldivar wrote:finished
From The the Picture of the ring, I suspect your melting temperature was a bit high, and those small air trapped bubbles are the pits you were fighting to remove on the surface. you can laupe them clear on a polished area .