Page 1 of 1

My first yellow resin cast

Posted: Fri Feb 03, 2017 5:56 pm
by joeyalbano
Had to build it at 41xy resolution cause it wouldn't fit on the 25xy platform.

Re: My first yellow resin cast

Posted: Fri Feb 03, 2017 10:28 pm
by Archerm
Looks nice and clean!!

Re: My first yellow resin cast

Posted: Sat Feb 04, 2017 12:23 pm
by printcast
I've been thinking about moving to yellow from green. Yellow is suppose to be the cleanest burn out. Have you done cast with both yellow and green? How do they compare? Did you use the stock Solus yellow settings? (now that I think about it, I'm not sure if there is a stock Solus setting for yellow, lol)

Re: My first yellow resin cast

Posted: Sat Feb 04, 2017 4:27 pm
by mongerdesigns
There is a setting for the yellow in Contour.

Re: My first yellow resin cast

Posted: Mon Feb 06, 2017 5:01 pm
by joeyalbano
I only worked with the yellow resin so can't really compare. I had to run this in 42xy cause it wouldn't fit on the 25xy platform.

Re: My first yellow resin cast

Posted: Fri Feb 10, 2017 2:41 pm
by robin
Here's some of my B9 Yellow resin castings in 14Y..
I don't know how to embed an image from dropbox so just click it to view. figured it out!

2017-02-10 09.11.26.jpg

Re: My first yellow resin cast

Posted: Thu Feb 23, 2017 10:48 pm
by MobiusJewelryDesign
That is a clean cast! What's your procedure? Setup? I use yellow too and I have used green. The green is nice to look at but I seem to get better results with the yellow. I appreciate you posting.

Re: My first yellow resin cast

Posted: Fri Mar 15, 2019 2:38 pm
by smokepl
Can I cure yellow in a microwave like I do with the green one? I been using emerald for a while and so far it is the best for casting using different casting companies, but I would like to try yellow. Should I be fine using same technique? clean in denatured alcohol, UV dry cure, microwave and blow dry. Thanks