Hi,
My printer doesn’t do homing after I changed the film. Any help is appreciated
Peter
Can not do homing after changing film
-
- Posts:8
- Joined:Fri Oct 20, 2017 2:40 am
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Can not do homing after changing film
Peter, just replied to your email.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
-
- Posts:8
- Joined:Fri Oct 20, 2017 2:40 am
Re: Can not do homing after changing film
Emil
Thank you
I think the cable is loose
Thank you
I think the cable is loose
Re: Can not do homing after changing film
Reset button on the back!
I was in the same sitch once and tried resetting the computer, turning the printer and projector off and on with no result, reset button on the back of the printer was the savior. Also the printer power cable can get loose, not sure what your US plugs are like but we bend our wall plug pins toward each other to make them stay in better sometimes
I was in the same sitch once and tried resetting the computer, turning the printer and projector off and on with no result, reset button on the back of the printer was the savior. Also the printer power cable can get loose, not sure what your US plugs are like but we bend our wall plug pins toward each other to make them stay in better sometimes
Who is online
Users browsing this forum: No registered users and 4 guests