My first print with SolusArtGrey, fresh FEP, Contour 2.1.17 Beta on default settings:
ImageA
ImageB
The supports are still connected to the build plate, but most of the print remains on the FEP blocking light to prevent further progress. Surprisingly difficult to remove from the FEP using the silicone spatula.
I've been having similar problems with the SolusProto lately, but put it down to being at the end of the bottle. Any suggestions?
SolusArtGrey failure
- Ben @ Mastercrafted
- Novice
- Posts:21
- Joined:Fri May 18, 2018 9:21 am
- Ben @ Mastercrafted
- Novice
- Posts:21
- Joined:Fri May 18, 2018 9:21 am
Re: SolusArtGrey failure
To follow up, this failure was caused a corrupt profile, fixed by:
• Edit > Open Profiles Folder
• Delete offending profile
• Select same profile in Contour (it will re-download?)
Hopefully, this will help others in the future.
• Edit > Open Profiles Folder
• Delete offending profile
• Select same profile in Contour (it will re-download?)
Hopefully, this will help others in the future.
Who is online
Users browsing this forum: No registered users and 136 guests