Casting advice needed

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
ketaeca
Novice
Posts:14
Joined:Sun Aug 20, 2017 10:13 am
Casting advice needed

Postby ketaeca » Sun Feb 10, 2019 3:11 pm

I think its a curing issue, but any advice will be appreciated.
Attachments
IMG-f0c8bcbe79dcab4c9d2c176032ee9869-V.jpg
IMG-bf17f6fe5d09880a3d8c51a486de0067-V.jpg
IMG-543fbfd3ee1be28df68bf37a203e6563-V.jpg
IMG-9aaba83df93bef9859835ac417bf9900-V.jpg
IMG-5a10a0613359b9147328def7fdab336a-V.jpg
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:

Re: Casting advice needed

Postby Jewelermdt » Mon Feb 11, 2019 2:57 am

Is that suppose to be one ring or single rings. The small opening between are causing problems. Investment breaking off. Tree is wrong. If they are separate rings, need more spacing between and feeder to each one.
ketaeca
Novice
Posts:14
Joined:Sun Aug 20, 2017 10:13 am

Re: Casting advice needed

Postby ketaeca » Mon Feb 11, 2019 7:39 am

It a small part that goes on top of a ring
rsaldivar
Solus Master
Posts:327
Joined:Tue Jun 30, 2015 8:51 pm

Re: Casting advice needed

Postby rsaldivar » Mon Feb 11, 2019 7:33 pm

What resin , what cure method ,what investment , what bur out ....
ketaeca
Novice
Posts:14
Joined:Sun Aug 20, 2017 10:13 am

Re: Casting advice needed

Postby ketaeca » Sat Mar 09, 2019 11:40 am

It was a curing issue. The lamp that i used for emerald was not curing the soluscast. Changed the curing unit and it perfect now. Thank you.
User avatar
rkundla
Solus Master
Posts:308
Joined:Sat Jan 09, 2016 6:01 am

Re: Casting advice needed

Postby rkundla » Thu Mar 14, 2019 1:22 am

What were you using and what did you change to in order to get the better result?

Who is online

Users browsing this forum: No registered users and 11 guests