Hey Everyone,
Been running smoothly on my printer since I got the hang of it with very few failed prints,
I just opened a new bottle of B9 Emerald and had transferred it into a bigger round bottle for easier mixing, I figured I'd pour the end of my previous bottle into the new one as there was only a touch in there and am pretty sure I've killed the whole bottle forgetting that I'd emptied the bottle weeks ago and transferred the remaining amount into smaller jars for easier mixing and had put 70% IPA in the bottle to clean it before chucking it, which I then poured into my fresh bottle of resin, I realised as soon as I started pouring but it was too late, am I correct in thinking it's ruined? I've just put the lid on and not touched it.
Help! I messed up
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Help! I messed up
Pretty sure that’s ruined. The alcohol is used to dissolve and clean the resin.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 156 guests