Any ideas after its done projecting a slice it seems to be stuck to the bat but pops off? Print still seems to be working..
http://www.youtube.com/watch?v=xJuiNTudGO8
Print pops off vat?
Re: Print pops off vat?
Print turned out great!
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print pops off vat?
Yes. That's normal for some resins. Especially on large cross sections.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Print pops off vat?
Onto my next print! So far so good! Easy to use...
mongerdesigns wrote:Yes. That's normal for some resins. Especially on large cross sections.
Re: Print pops off vat?
Print worked! Every detail was perfect!
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print pops off vat?
Would be cool to see some photos
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 16 guests