Hi guys,
i would like to know if you change something on the Z axis control? Yesterday I print a part with 2mm high on the BP with 1.4.10 and it was okay, but I just update to 1.4.13 and the same part came at 2.86mm???
Cheers,
Barth
Contour 1.4.13 Z Trouble
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Contour 1.4.13 Z Trouble
No changes were made to that aspect of the software. Are you using the scaling compensation? Try uninstalling 1.4.13 and going back to the 1.4.10 to see if that fixes the issue.
Although I print with .13 every day and I didn't notice any issue like that.
Although I print with .13 every day and I didn't notice any issue like that.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Contour 1.4.13 Z Trouble
My bad... It's not a soft issue but a resin issue. When I print with Solus Proto it's okay but when I print with my brand new Porcelite I have 3mm instead of 2mm
I calibrate my BP to be sure, but nothing change.
Any idea?
I calibrate my BP to be sure, but nothing change.
Any idea?
Who is online
Users browsing this forum: No registered users and 1 guest