A few castings from yesterday. All were emerald prints cast using Plasticast.
***Totally Stoked!!***
Re: ***Totally Stoked!!***
Hello Mark
Top class print & casting you get always.....i.m dont get same for rings it gets lines i need to fill up with super glue or wax to make levelling......if possbile can you share yr setting for 80x45- 25z or 20z....
DId try 2mm rod same height they comes out nice.
https://drive.google.com/file/d/0B0kqKa ... sp=sharing
Top class print & casting you get always.....i.m dont get same for rings it gets lines i need to fill up with super glue or wax to make levelling......if possbile can you share yr setting for 80x45- 25z or 20z....
DId try 2mm rod same height they comes out nice.
https://drive.google.com/file/d/0B0kqKa ... sp=sharing
Re: ***Totally Stoked!!***
I will check monday.
Re: ***Totally Stoked!!***
mongerdesigns wrote:I don't think that's overcure. His build tables are probably calibrated a little too close. So it's compression of the first few layers.
Ahh, I didn't think of that.
Re: ***Totally Stoked!!***
dcpattni wrote:Hello Mark
Top class print & casting you get always.....i.m dont get same for rings it gets lines i need to fill up with super glue or wax to make levelling......if possbile can you share yr setting for 80x45- 25z or 20z....
DId try 2mm rod same height they comes out nice.
https://drive.google.com/file/d/0B0kqKa ... sp=sharing
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: ***Totally Stoked!!***
Thank you for sharing.
Re: ***Totally Stoked!!***
I have a few two tone helicoil rings to finish up for next week. This will be the white gold helicoil insert. there will be a yellow gold cap on each end of the helicoil. Designed with a constant .5mm overall wall thickness and so the only support needed is the .5 mm fin support around the bottom.
Re: ***Totally Stoked!!***
A few prints from today!!
Re: ***Totally Stoked!!***
Mark, Absolutely outstanding !!!!
What resolution do you normally use , 48x27 or 80x45 ? Reason I ask, a few post back you showed your settings for 80x45.......I've had a issue growing a 12 mm wide ring size 13+ and it took up the whole scene. Should I have switched to 80x45? Thanks...>David
What resolution do you normally use , 48x27 or 80x45 ? Reason I ask, a few post back you showed your settings for 80x45.......I've had a issue growing a 12 mm wide ring size 13+ and it took up the whole scene. Should I have switched to 80x45? Thanks...>David
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: ***Totally Stoked!!***
Hey David
He has 2 printers. One set up for each size.
If you have room all around the ring, it should print fine. Just use a lot of supports. Even half way up on side of ring to keep it from sagging mid print.
He has 2 printers. One set up for each size.
If you have room all around the ring, it should print fine. Just use a lot of supports. Even half way up on side of ring to keep it from sagging mid print.
Who is online
Users browsing this forum: No registered users and 31 guests