SolusCast: Cracks in heavy model
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Here is a new print.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: SolusCast: Cracks in heavy model
Nice print, Mike. Which resin is that?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: SolusCast: Cracks in heavy model
epic m.....
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: SolusCast: Cracks in heavy model
Emerald, Epic. 50%
Re: SolusCast: Cracks in heavy model
@mark why mixing emerald and epic?
now I bought a new bottle and is 100eur cheaper than last year...
now I bought a new bottle and is 100eur cheaper than last year...
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: SolusCast: Cracks in heavy model
kostyo wrote:@mark why mixing emerald and epic?
now I bought a new bottle and is 100eur cheaper than last year...
Simple. the print quality is beyond any expectation . Even though the Epic casts good, but with the Emerald mix, the casting result is superior.
I will post some close-up pics.
Re: SolusCast: Cracks in heavy model
@mark this print 25mikrons or 42?
I also thought I was trying to mix the emerald with the epic, but I am very happy as the epic cast now when I tuned postcuring.
but I'm curious about your photos
I also thought I was trying to mix the emerald with the epic, but I am very happy as the epic cast now when I tuned postcuring.
but I'm curious about your photos
Re: SolusCast: Cracks in heavy model
Where can Epic be purchased?
Mix 50/50 Epic/Emerald. Are you using Emerald settings for printing? I assume the burnout for Emerald will be fine for this 50/50.
Thx
Mix 50/50 Epic/Emerald. Are you using Emerald settings for printing? I assume the burnout for Emerald will be fine for this 50/50.
Thx
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: SolusCast: Cracks in heavy model
kostyo wrote:@mark this print 25mikrons or 42?
I also thought I was trying to mix the emerald with the epic, but I am very happy as the epic cast now when I tuned postcuring.
but I'm curious about your photos
25 microns All the way. The only one setting we use.
Re: SolusCast: Cracks in heavy model
HEY! Looks like we have a new castable resin on the way, SolusWax. The name alone sounds promising to me. Can not wait for a clean easy burnout.
Who is online
Users browsing this forum: No registered users and 11 guests