Hi all,
so I've got my new printer, assembled, set up and calibrated it, opened a calibration box model in Contour - and voila, the printer doesn't start homing. Unplugged USB (COM6 port if it's important), turned off printer, then put it back - again nothing. Contour SW sees it on COM6, but no Homing. Any ideas why? other than bad karma..
Thank you!
New printer - doesn't do Homing
Re: New printer - doesn't do Homing
Hi,
Did you download and install the arduino software? It has the drivers you need to run the printer.
Where are you located?
Did you download and install the arduino software? It has the drivers you need to run the printer.
Where are you located?
Re: New printer - doesn't do Homing
reify wrote:Hi,
Did you download and install the arduino software? It has the drivers you need to run the printer.
Where are you located?
Hello,
yes I have, and I'm in Amsterdam.
Who is online
Users browsing this forum: No registered users and 94 guests