This section will include any new tips and tutorials related to the Solus.
2 posts • Page 1 of 1
Hello everyone I have problem how to suport this ring for printing. For all help thank you!
- Solus Master
- Posts: 793
- Joined: Sun Jul 19, 2015 10:38 pm
- Location: N.W. Florida
What resin are you using? You will need to support ALL prongs that face at a downward angle and perpendicular to the base. Might be better to angle the ring in Y about 15 degrees. If your using Contour see what it put in for support. You may have to add a few where it misses.
Who is online
Users browsing this forum: No registered users and 0 guests