My first print with SolusArtGrey, fresh FEP, Contour 2.1.17 Beta on default settings:
The supports are still connected to the build plate, but most of the print remains on the FEP blocking light to prevent further progress. Surprisingly difficult to remove from the FEP using the silicone spatula.
I've been having similar problems with the SolusProto lately, but put it down to being at the end of the bottle. Any suggestions?
Discuss 3d printing resins
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests