This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
4 posts • Page 1 of 1
Hello everyone! I have problem to support this ring. I try many ways all prints fail.
Split it and print separately. Put together and glue it with resin before curing.
- Solus Master
- Posts: 749
- Joined: Sun Jul 19, 2015 10:38 pm
- Location: N.W. Florida
Or try taking it apart and do 3 separate sections. Top cluster, donuts, and shank all separate.
You have to add supports to all the prongs even if it doesn't show "green" in the Contour software. Also, lower the z-lift speed to 75 or less for such delicate prints.
Who is online
Users browsing this forum: No registered users and 5 guests