Calibration help

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Mikkopee
Novice
Posts: 35
Joined: Mon Feb 13, 2017 1:18 pm

Calibration help

Postby Mikkopee » Thu Oct 31, 2019 9:55 am

How do I calibrate this?

All cubes are 8x10mm

Y-axis I can fix, but X -axis is problem.. its fine in the middle but both sides are too small. How do I fix this?

Projected grid is fine and straight lines.
And measuments are 80x45mm like it should be.
Attachments
calibration1.jpg
User avatar
Messerbr
Solus Expert
Posts: 161
Joined: Tue Jan 05, 2016 2:54 pm
Location: North Carolina
Contact:

Re: Calibration help

Postby Messerbr » Thu Oct 31, 2019 1:12 pm

Have you fully calibrated the printer with a 10mm cube and used the "Scale Adjustment" feature to correct any inaccuracies?
Mikkopee
Novice
Posts: 35
Joined: Mon Feb 13, 2017 1:18 pm

Re: Calibration help

Postby Mikkopee » Thu Oct 31, 2019 2:26 pm

Messerbr wrote:Have you fully calibrated the printer with a 10mm cube and used the "Scale Adjustment" feature to correct any inaccuracies?

Yes, but when sidecubes are OK, middle cubes are too big and vice versa.
And Y-axis is no problem and scale adjustment works fine but X-axis is problem since middle its fine but sides are too small and I dont know how to fix those.
User avatar
Messerbr
Solus Expert
Posts: 161
Joined: Tue Jan 05, 2016 2:54 pm
Location: North Carolina
Contact:

Re: Calibration help

Postby Messerbr » Thu Oct 31, 2019 5:14 pm

hmm, probably has something to do with the projection and lens curvature. might try stretching the projection grid out a little at those corners by 0.2ish mm to compensate for it?

Who is online

Users browsing this forum: No registered users and 0 guests