Problems with the Print

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
BasilL
Posts: 1
Joined: Wed Nov 27, 2019 3:01 am

Problems with the Print

Postby BasilL » Wed Nov 27, 2019 3:23 am

Hi
I have been using my current Solus printer and projector for the past year. We had a problem start initially, but everything worked out and I was able to print good models with it.
We started having problems with the printer since the start of this month. I remember there was a computer update and the next time I print, there was terrible problems with the print job.
I have tried everything I know to do, including changing the resin, changing the film, recalibrating the printer, the grid, cleaning the lens, everything. But the print job still comes out really bad.
Attached are some of the images.
I would appreciate any help or suggestions. Thank you very much.
Attachments
20191125_154747.jpg
20191125_154742.jpg
20191125_154621.jpg
20191125_154602.jpg
User avatar
Jewelermdt
Solus Master
Posts: 780
Joined: Sun Jul 19, 2015 10:38 pm
Location: N.W. Florida
Contact:

Re: Problems with the Print

Postby Jewelermdt » Wed Nov 27, 2019 4:31 am

After update did you check the RGB computer display settings. Make sure you check the projector settings. Most times an update reverts the setting back to default. Fairly certain that is your problem.

Who is online

Users browsing this forum: No registered users and 0 guests